Home > Beep Codes > Post Error Codes Compaq

Post Error Codes Compaq

Contents

Disconnect any other diskette controller devices (tape drives). These beeps inform you that your hardware is in good working order. Red Power LED flashes five times, once every second, followed by a two second pause. Replace the IC if possible 4-2-4 Unexpected interrupt in protected mode- This is a CPU problem. http://ismymailsecure.com/beep-codes/post-error-codes-hp.html

How does HP install software and gather data? Replace front chassis fan. 515-Power Supply fan not detected Power supply fan is not connected or may have malfunctioned. See the Hardware Reference Guide for instructions on installing a new battery, or contact an authorized dealer or reseller for RTC battery replacement. 163-Time & Date Not Set Invalid time or Enter the correct serial number in Computer Setup.

Hp Beep Codes

two-tone siren Low CPU Fan speed, Voltage Level issue Additional information Additional information on the POST and how a computer works? Replace defective part. Or, in the event your computer requires service, you can use this code and information when talking with the service personnel.

Reboot the computer. If the error still persists, replace the system board. 2233-HECI error during MEBx execution Error occurred during MEBx execution which fails into “MEI or HECI” grouping. If the problem persists, replace the motherboard. Hp Beep Codes 6 Beeps Enter Computer Setup and run the Drive Protection System test under Storage > DPS Self-test.

Hardware 3.2 The embedded controller has timed out waiting for BIOS to return from memory initialization. Hp Beep Codes 5 Beeps May 24, 2008 #16 Maccs TS Rookie Excellent work . Ensure that none of the keys are depressed. Check connector for bent or missing pins.

With the development of the Extensible Firmware Interface (EFI) environment, many HP Pavilion and Compaq Presario computers built in 2011 or later can use blinking LEDS to identify hardware component reporting Hp Beep Codes 1 Short 1 Long Replace the motherboard. 9 short BIOS ROM checksum error: The BIOS ROM has failed. Reboot the computer. Repeated high frequency beeps while PC is running Overheating processor (CPU) Repeated beeps alternating high & low frequency Issue with the processor (CPU), possibly damaged If any other correctable hardware issues

Hp Beep Codes 5 Beeps

The speed at which the computer loads the operating system and the extent to which it is tested are determined by the POST mode selection. http://h20564.www2.hp.com/hpsc/doc/public/display?docId=emr_na-c02032573 Run Computer Setup or Windows utilities. Hp Beep Codes A loose or missing CPU, BIOS chip, Crystal Oscillator, or Chipset chip will cause the motherboard not to function. Hp Laptop Beep Codes If the hard drive LED turns green, the power button is working correctly.

If the computer stops beeping, a memory module might not have been fully seated or connected. have a peek at these guys Status information displayed along with the error provides further clarity into the failure. Replace the IC if possible 2-2-1 64KB RAM failure Bit 4; This data bit on the first RAM IC has failed. If the error persists, update to the latest BIOS version. Hp Led Codes

Repeating Short Beep No Power, Loose Card, or Short. 1 Long and 1 Short Beep Motherboard issue. 1 Long and 2 Short Beeps Video (Mono/CGA Display Circuitry) issue. 1 Long and Press the Power button to start the computer and repeatedly press the f10 key to enter the BIOS Setup menu. On many computers, the computer speaker is disabled when a jack is connected.Is the volume too low? http://ismymailsecure.com/beep-codes/post-error-codes.html For example, there might be two beeps, a short pause, one beep, a short pause, one beep, a short pause, and then three beeps; this is represented as 2-1-1-3 in the

Beeps Description 1 short beep and 1 long beep Memory problem 2 short beeps and 1 long beep (repeats 5 times) Unable to initialize video or video card required but not Hp Beep Codes 3 Beeps Replace the IC if possible 3-1-1 Slave DMA register failure The DMA controller has failed. The white LED blinks to represent the minor error category (short blinks).

If the computer cannot boot to the BIOS Utility, try removing and reseating the memory and the hard drive, and then repeat the following steps to perform the memory self-test.

If third-party memory has been added, test using HP-only memory. If the error persists after replacing memory modules, replace the system board. 213-Incompatible Memory Module in Memory Socket(s) X, X, ... Check the CPU fan or BIOS settings for proper fan speed. Hp Compaq Beep Codes 4 Beeps The BIOS information is stored in the CMOS hardware section of the motherboard and the contents are maintained by applying constant electrical current using a CMOS battery .

Reseat the video adapter or replace the adapter if possible. 1 long, 3 short Peripheral controller error: One or more of the system peripheral controllers is bad. Z7_3054ICK0KGTE30AQO5O3KA30N0 hp-concentra-wrapper-portlet Actions ${title} Loading... Make sure there is a memory module in the black DIMM1 socket and that it is properly seated. this content If the error still persists, replace the system board. 2205-Interface error during MEBx execution MEBx operation experienced a hardware error during communication with ME.